Logging to file "DUS.log"

Configuring the simulation environment.


-------------------------
Diagnostic Utility System
-------------------------

Loading DUS.

Cold load complete, P: 006770 (ADDS 11)

Starting the diagnostic.


Diagnostic/Utility System Revision 03.06
Enter Your Program Name (type HELP for program information)
:IOMAP
               IOMAP            Revision 00.22
 
 
          Enter 'GO' to continue
                'GO ,1' to continue with Line Printer
 
                'GO 1' for Optional Test Sections
                'GO 1,1' to run Optional Test Sections with Line Printer
 
                ('LC' to List Commands)
 
>GO
























 IOMAP            SYSTEM I/O CONFIGURATION
-----------------------------------------------------------------
>Cold load switch register settings: Channel=12 Device=0 
>System console is device 0 on channel 1
-----------------------------------------------------------------
Channel  1  ID=!1        Async. Data Comm. Channel (ADCC)
  Devices 0-3  ID=!4080    Devices on  ADCC MAIN     (CODE=1,2)
  Devices 4-7  ID=!4080    Devices on  ADCC EXTEND   (CODE=1,2)
-----------------------------------------------------------------
Channel 12  ID=!0    General I/O Channel  (GIC)
  Device 0  ID=!183    7970E Mag Tape Controller           (CODE=2)
    Unit 0               7970E Mag Tape Drive
-----------------------------------------------------------------
Explanation of '(CODE=   )'
     1 implies:  NO LOOPBACK Capability.
     2 implies:  NO SELFTEST Capability. 
     3 implies:  LOOPBACK/SELFTEST only available in product diagnostic.
------------------------------------------------------------------

End of pass 1
 


Diagnostic/Utility System Revision 03.06
Enter Your Program Name (type HELP for program information)
:
Simulation stopped, P: 070323 (LOAD Q-4)
sim> q
Goodbye
Log file closed